Norcold Board Kit / Controls Adapters Included 637779 (old 633292) Models N82X/ N62X
Every Norcold refrigerator has a specific power board and optical board. They are completely proprietary with eachother because they need to communicate back and forth. This kit will work on any N82X/N62X model refrigerator that has an obsolete optical board assembly. This is determined by the serial number located on a decal inside the refrigerator box. If your serial number is below 9126825, this is the kit you need. If your serial number is above 9126825, you need:
Norcold Optical Board 628974 (click)
Power Board w/ wire adapter
Lamp/thermistor wire (the jumper wire that goes across LI IN and LI OUT)
Installation instructions
- N621/N6213/N621F/N621SS
- N622 WINNEBAGO
- N623
- N624
- N820
- N821/N821BK/N821BKF/N821F/N821IM/N821V
- N822/N822F
- N823
- N824
32 Reviews
-
Worked Perfect
Fridge worked good before repair, just wouldn't shut off with switch. Bought the kit for both optical control and power board, easy installation, just pay attention to where wires came from and mark them. Good as new, back in business, Wish my rooftop AC was that easy. Highly recommend both vendor and part.
-
NorCold N821 Control Board
Parts as described. Great price. Received parts in 3 days. Would of been 2 but, FedEx dropped of at wrong address. Address was correct on shipping label. Just installed today. Frig will at least come on now, just giving it time to see if it cools. Install a little difficult just due to tight space. Will for sure order from you again!!
-
Great Product
After getting the dreaded "f" error code, and sorting through the trouble shooting logic in the service manual for my N62x unit, a new power board was in order. Looked at a site which advertised a new board for $240. Then found that Norcold had this item which offered a new power and optical board for $150 plus s/h. Would have given 5 stars except for two issues. First, very complete installation instructions given, but were for several kits. Installation goes easier if you set down and mark out the portion of the instructions which do not apply to your frig before you start work. Secondly, when through with the installation, I was left with a pair of 15 inch long red jumpers. Spent time rereading the instructions, but could never figure why they were in the kit. however, installation was simple and easy and unit now functions perfectly.
-
Power board Happiness
I went to Camping World due to refrigerator not working on gas. It is a Norcold N621. They wanted over $300.00 PLUS installation to repair it. I found Norcold Parts online and found that the original board was only $200.00 or the upgraded board AND Controller was only $149.00. I ordered the upgraded board kit. The instructions were very clear and easy to follow once I eliminated the stuff for the other units the board covered. It took me 45 minutes to remove and replace the complete kit. EASY. Very happy with my experience.
-
633292 board kit
I had a bad power board for my N821 and found out Norcold no longer makes that board. This kit came with two completely different boards with adapters to connect the new wire harnesses. The installation was painless and it's now working properly.
Reviews
