Invision 100902 Main Control Board (fits the InVision 10.7)

The InVision 100902 Main Control Board is a replacement electronic control module for compatible InVision 10.7 cu. ft. 12V RV refrigerators. This board works with the refrigerator's compressor cooling system, helping control compressor operation so the refrigerator can properly cool the fresh-food and freezer compartments.

If your InVision refrigerator has power but the compressor will not start, runs intermittently, or the refrigerator is no longer cooling properly, a failed compressor control board may be one possible cause.

Product Features

• Genuine replacement-style InVision main control board
• Part number: 100902
• Designed for compatible InVision 10.7 cu. ft. RV refrigerators
• Works with the refrigerator's 12V compressor cooling system
• Controls power and operation of the refrigeration compressor
• Direct replacement for a failed or damaged compressor controller
• Helps restore normal compressor and cooling operation

Fits

Designed for compatible InVision 10.7 cu. ft. refrigerator models using the 100902 compressor control board.

Important: InVision offers several different 10.7 cu. ft. refrigerator configurations, including bottom-freezer, top-freezer, left-hand, right-hand, and dual-swing versions. Verify the 100902 part number on your original board or confirm compatibility using your refrigerator model number before ordering.

Common Symptoms of a Failed Main Control Board

A replacement compressor control board may be needed if:

• Refrigerator has power but is not cooling
• Compressor does not start
• Compressor starts and stops unexpectedly
• Refrigerator cooling is intermittent
• Compressor remains off even though cooling is being requested
• Original control board shows visible electrical or heat damage

These symptoms can also be caused by wiring, low 12V supply voltage, the compressor itself, temperature controls, or other refrigerator components, so proper diagnosis is recommended before replacing the board.

Installation

The compressor control board is located in the refrigerator's compressor/electrical system. Installation generally involves disconnecting 12V power, accessing the rear compressor compartment, disconnecting the original board, and transferring the electrical connections to the replacement board.

Always disconnect power to the refrigerator before servicing.