Norcold Power Board 621271001 (fits the 1200 models)

The power/ circuit board is the gateway of voltage through the refrigerator. This board is intended for Norcold 1200 models with a serial number range between 832171 and 8981138.

Fits these Norcold refrigerator models:

• 1200LR series (gas/electric): 1200LR, 1200LRBK, 1200LRSS, 1200LRWH, 1200LRIM, 1200LRIMD, 1200LRIMBK, 1200LRIMBKD, 1200LRIMSS, 1200LRIMSSD, 1200LRIMWH
• 1201LR series (gas/electric): 1201LRIM, 1201LRIMSS, 1201LRIMSSD, 1201LRIMWPM

Serial number note (1200 series): Norcold lists this part for gas/electric models with serial numbers 0832171 to 8981138; gas/electric units built on or after 02/14/1999.

If your serial number is above 8981138, you need the following board:

Norcold New Style Power Board (<-click)

There is an upgraded version of this older style 1200 board made by Dinosaur Electronics. It also fits all 1200 models with a serial number below 8981136 and can be ordered at the link below:

Norcold Upgraded 1200 Power Board (<-click)

Troubleshooting

Potential problems that a new power board could solve:

• Refrigerator not sensing AC power
• Refrigerator not sensing AC heating element
• Refrigerator not sensing a flame
• Refrigerator not powering on
• Refrigerator incapable of resetting
• Intermittent issues
• SR code display
• If any electrical burn marks are present anywhere on front or back of power board, you should replace it.

Installation

Time:

• 30 minutes or less

Tools:

• Ratchet set
• Screwdriver

Steps:

• Turn your battery switch to OFF
• Remove power board cover
• Take a picture of the board before disconnecting any wires
• Disconnect all wires and remove defective board
• Place new board on old board cover base and connect wires
• Before placing board cover on, turn battery switch ON and power up refrigerator to verify everything is connected and that there are no faults present. If everything is working, put cover back on.